[. . . ] Before use, read the warnings and other information in this manual and in the documentation provided with the camera. Federal Communications Commission (FCC) Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. [. . . ] ?????????????????????? The Low-Cut Filter Switch Select FLAT for normal use, L-CUT to reduce wind noise and other low-frequency noise. Note that noise may be recorded if the switch is operated during recording. ?????????????????? 3 4 Attach the wind screen by placing the groove in the screen over the projection on the microphone (Figure 1-a). Slide the mounting foot into the camera accessory shoe (Figure 1-b) and tighten the lock ring (Figure 1-c). Note that vibration reduction may cause the microphone to wobble if it is shaken while attached to the camera. Unless stated otherwise, all figures are for an ambient temperature of 20 C/68 F. Specifications are independent of any device to which the microphone may be connected. Improvements to this product may result in unannounced changes to specifications and external appearance. ????????????????? Safety Precautions To ensure proper operation, read this manual thoroughly before using this product. After reading, be sure to keep it where it will be read by all those who use the product. In the event of malfunction, take the product to the point of purchase or a Nikon-authorized service center for inspection. Should you notice heat, smoke, or an unusual smell coming from the equipment, cease use immediately and take the product to the point of purchase or a Nikon-authorized service center for inspection. [. . . ] The ME-1 may pick up sounds made by the camera or lens during recording. The ME-1 may pick up sounds caused by repositioning the microphone during recording. [. . . ]